Maintenance - SLAT RMS IP 12V Notice D'utilisation

7.3.3 RESET
If the rack has been incorrectly set (password forgotten, invalid Ethernet configuration, etc.), it may be that the
Ethernet communication does not work.
To update the original configuration of the rack, use the following procedure:
•
Unplug the rack power cord.
•
Open the battery fuse.
•
Press the button.
•
Reconnect the power cord to the rack, while keeping the button pressed.
•
The display shows: "RESET"
o
Still keep the button pressed. Stars are displayed. You must wait for 10 stars appear.
Important: If you release the button before all the stars are displayed, the reset
procedure will be canceled.
o
The "OK !" message appears to indicate that the reset has been performed.
o
Release the button at this point for the rack to restart as normal.

8 Maintenance

In order to ensure maximal and durable service, we strongly recommend that your product be maintained clean
and ensure that it is installed in a dry and ventilated location. We shall in no case be liable for damages
associated with improper use or incorrect maintenance of the equipment.
WARNING
Replacing the original battery with a battery of incorrect type may result in an explosion hazard.
Used batteries must be disposed of in compliance with recycling requirements.
71
180140005Ca
Code: - NDU:
Edition: 03/18
NOT140004Ca