SLAT RMS IP 12V Notice D'utilisation page 68

Input data: system
Name in the MIB
systemIdentificator
systemState
runningMode
alarmInput
alarmOutput
•
Redirect page: This page appears when an administrator changes the connection settings of the board
(IP address, subnet mask, router). It is used to redirect the administrator who made the change to the
login page of the card with the correct address.
Designation
Rack name e.g.: RMS IP:
System state:
// bit 15: Test state 54-4 (1 = failure)
// bit 14: Battery mesh fault (1 = out of order)
// bit 13: Low voltage battery fault (= 1)
// bit 12: Converter state (OK = 1)
// bit 11: Voltage presence (=1 if voltage)
// bit 10: Orange LED (=1 if the led is orange)
// bit 9: rating of the power board
// bit 8: rating of the power board
// bit 7: Fuse 8 fault (=1)
// bit 6: Fuse 7 fault (=1)
// bit 5: battery fuse fault (=1)
// bit 4: Battery temp sensor fault (= 1)
// bit 3: AUX Fuse fault TO (=1)
// bit 2: Free
// bit 1: Internal communication state (OK=1)
// bit 0: CTB relay active (=1)
Not used
Not used
Rack fault = systemState:
System state:
// bit 15: Test state 54-4 (1 = failure)
// bit 14: Battery mesh fault (1 = out of order)
// bit 13: Low voltage battery fault (= 1)
// bit 12: Converter state (OK = 1)
// bit 11: Voltage presence (=1 if voltage)
// bit 10: Orange LED (=1 if the led is orange)
// bit 9: rating of the power board
// bit 8: rating of the power board
// bit 7: Fuse 8 fault (=1)
// bit 6: Fuse 7 fault (=1)
// bit 5: battery fuse fault (=1)
// bit 4: Battery temp sensor fault (= 1)
// bit 3: AUX Fuse fault TO (=1)
// bit 2: Free
// bit 1: Free
// bit 0: CTB relay active (=1)
180140005Ca
Code:
Edition: 03/18
68
NOT140004Ca
- NDU: