Cleaning Honeycomb Assemblies - Hussmann ANSI/NSF-7 I Impact Série Manuel D'installation

P/N 0487074G

CLEANING HONEYCOMB ASSEMBLIES

Honeycombs should be cleaned every six
months. Dirty honeycombs will cause merchan-
disers to perform poorly. The honeycombs may
be cleaned with a vacuum cleaner. Soap and
water may be used if all water is removed from
the honeycomb cells before replacing. Be careful
not to damage the honeycombs.
Single Deck Cases
1. Using a flat object such as a screw driver,
compress the honeycomb and remove it
from its retainer.
2. Clean and dry the honeycomb.
3. After cleaning, replace in reverse order.
Multi-deck Cases
1. Loosen or remove screw to free honeycomb.
2. Clean and dry the honeycomb.
3. After cleaning, replace honeycomb and slide
retainer forward and to the right.
Damaged honeycomb must be replaced.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Retainer
Honeycomb
Screw
Retainer
Honeycomb
Medium Temperature
5-3