Hussmann ANSI/NSF-7 I Impact Série Manuel D'installation page 21

P/N 0487074G
2. Engage each power socket cap and ensure
that each cap is fully seated before cleaning.
Ensure the proper seating of the cap at all
times when the plug is not engaged.
R
I
G
H
T
3. Clean the merchandiser as described in the
Care and Cleaning paragraphs of Section 5 –
Maintenance. Keep liquid out of sockets.
4. Verify that power is at the case and turned on.
Verify that the case light switch is turned
"OFF." Switch is located in the canopy, on
the left, behind first row of lamps.
5. See the illustration below. It is typical of D5,
C5, and D6 models. Note that other models
will have fewer rows of shelves.
Socket with Cap Installed
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
W
R
O
N
G
Light Switch Location
Starting from the left-hand bottom section,
choose the location for the first shelf, X-1.
Secure the shelf in the slotted upright. Make
certain that the shelf is level and that ends are
in the same slot on the left and right upright.
It is important that shelf brackets be proper-
ly seated in the slotted upright.
6. Remove the cap from
the rear wall socket and
insert the shelf plug in
the socket. Secure cord
under clip.
10 Sockets in
8-ft Case
X-13
X-10
X-7
X-4
X-1
Always work Left to Right,
and Bottom to Top
Medium Temperature
Push in clip
15 Sockets in
12-ft Case
X-15
X-14
X-12
X-11
X-9
X-8
X-6
X-5
X-3
X-2
4-3