Hussmann ANSI/NSF-7 I Impact Série Manuel D'installation page 16

D
3-2
RIP
Produce / Meat Wide Island Merchandisers
See the case data sheet set for dimensions. Each
waste outlet will be interconnected with factory
installed drip piping. When a 6 ft (1829 mm) end
merchandiser is ordered to be joined to a center
case at the factory, its waste outlet can also be
interconnected as shown. A drain piping connect
kit is required.
End Case
P/N 0487074G
P S
IPING AND PLASHGUARDS
Raceway
6, 8 or 12 Ft Case
(1829, 2438 or 3658 mm Case)
Water seal outlet must clear front skid rail.
Each merchandiser is supplied with a 2 in.
(51 mm) water seal, an adapter, a plug and a
street ell. The street ell and water seal must be
installed to prevent air leakage and insect
entrance into the merchandiser. They should be
installed as shown below.
Base
Cleanout Adapter
and Plug Standard
NOTE: