Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
S
4-2
TART UP
MULTI-DECK SHELF ALIGNMENT
Taped to one of the shelves of each merchandiser
is a small plastic bag containing shelf alignment
strips. These strips are designed to enhance the
appearance of the shelves by aligning the front
edge of each shelf with that of an adjacent shelf.
When installing shelves:
1. Insert one of the alignment strips into the slot
behind the front edge of each shelf.
2. After all shelves are installed, slide the strip
across the shelf joint wherever two shelves
are adjacent. This will lock them together.
Shelf Alignment Strip
5
(
5/8 x 6 in. – 16 x 32 mm)
MULTI-DECK SHELF CONFIGURATION
The bottom display shelves can be adjusted to
accommodate shallow or volume displays (bulky
items such as hams or chickens). The upper
shelves are individually mounted in 1 in. (25 mm)
increments and have two-, three-, or four-position
brackets permitting shelves to be placed in a flat
or down-tilt position (see illustration). Front
product stops are recommended when shelves are
placed in the down-tilt position.
P/N 0487074G
/ O
PERATION
Shelf Alignment Strip
/
x 6 in. —16 x 152 mm)
8
Case performance will be degraded if peg
shelves are used without baffles. Unauthorized
specialty shelving may cause poor case perfor-
mance also. Consult your Hussmann representa-
tive to ensure optimum performance of
Hussmann equipment.
2-Position
3-Position
PROCEDURE FOR INSTALLING LIGHTED
SHELVES WITH SINGLE-PRONG
CONNECTOR
Shelf lighting uses parallel
wiring. Please follow these
instructions to ensure good
contact between male and
female connectors.
1. SHUT OFF POWER TO CASE. REMOVE
ALL SHELVES.
4-Position
Publicité
Chapitres
Table des Matières
