Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5
LIGHT BULB REPLACEMENT
To reduce the possibility of premature bulb failure, do
not touch new bulbs with bare fingers. Use clean, dry
tissue or paper towel to handle the glass portion of the
bulb.
For vehicles with headlights, locate the screws on
backside of cowl that secure headlight. Remove
screws, pull headlight out and disconnect wires. Con-
nect wires to new headlight, install in cowl and secure
with screws previously removed.
To replace the turn signal light bulb, support turn signal housing from backside
of cowl while removing two screws securing lens. Install new bulb and replace
lens.
To replace the tail and brake light bulb, roll the rubber bezel from around the
edge of the taillight and remove lens. Install replacement bulb and replace
lens. To replace the tail and brake light bulb, remove hardware securing lens
and remove lens. Install replacement bulb.
FUSE REPLACEMENT
To replace fuses, locate the fuse block under the driver side seat. Pull out old
fuse and replace with a new automotive type fuse. Headlight and taillight bulbs
and fuses are available from a local Distributor, an authorized Branch or the Service Parts Department.
5 - 6
Tire/wheel style
may vary
'Cross Sequence'
1
3
3
4
2
Wheel Installation
'Cross Sequence'
1
4
5
2
Inside
of Cowl
Headlight
Casing
Screw
Headlight
Bulb
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender
Publicité
Chapitres
