Wheels And Tires; Tire Repair - Cushman HAULER 1200X E Manuel De L'utilisateur

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
When lifting the vehicle, position the jacks and jack stands at the areas indicated only.
Remove payload from vehicle before lifting. No person(s) should be in or on the vehicle while
lifting.
To raise the entire vehicle, install chocks in front and behind each front wheel. Center the jack
under the rear frame crossmember. Raise the vehicle enough to place a jack stand under the
outer ends of the rear axle.
Lower the jack and test the stability of the vehicle on the two jack stands.
Place the jack at the center of the front axle. Raise the vehicle enough to place jack stands
under the frame crossmember as indicated.
5
Lower the jack and test the stability of the vehicle on all four jack stands.
If only the front or rear of the vehicle is to be raised, place the chocks in front and behind each wheel not being raised
to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.

WHEELS AND TIRES

Tire Repair

Tool List
Lug wrench, 3/4" ..........................................................1
Impact wrench, 1/2" drive ............................................1
A tire explosion can cause severe injury or death. Never exceed the inflation pressure rating on
the tire sidewall.
To reduce the possibility of tire explosion, pressurize tire with small amounts of air applied inter-
mittently to seat beads. Due to the low volume of the small tires, overinflation can occur in sec-
onds. Never exceed the tire manufacturer's recommendation when seating a bead. Protect face
and eyes from escaping air when removing a valve core.
To reduce the possibility of severe injury caused by a broken socket when removing wheels, use
5 - 4
Flat Portion
of Frame
Outside End
of Rear Axle
Lifting The Vehicle
View from Underside of Vehicle
Qty. Tool List
Impact socket, 3/4", 1/2" drive ................................ 1
Torque wrench, 1/2" drive ....................................... 1
Center of
Front Axle
Qty.