Operating Range; Minimum Average Water Temperature [°C] - AERMEC VED 030 I Manuel D'utilisation Et D'entretien, Instructions D'installation

3.

OPERATING RANGE

Maximum recommended entering water temperature
(main coil)
Minimum flow rate (main coil)
Maximum flow rate (main coil)
Minimum flow rate (heating only coil accessory)
Maximum flow rate (heating only coil accessory)
Maximum recommended entering water temperature
(main coil)
Minimum flow rate (main coil)
Maximum flow rate (main coil)
Minimum flow rate (heating only coil accessory)
Maximum flow rate (heating only coil accessory)
The earth leakage of several units con-
nected to one circuit breaker is added.
It is recommended to check the rating
of the circuit breaker and it may be
Water temperature
In order to avoid air stratification and there-
fore achieve better mixing it is advised not
supply the fan coil unit with water hotter
than 65°C.
Minimum average water temperature
If the fan coil unit operates continuously
in cooling mode in a room with high
relative humidity, condensate might form
on the air discharge and unit casing. This
condensate might be deposited on the
floor and on any objects underneath. To
prevent the formation of condensation
on the exterior of the unit while the fan
is operating, the average water tempera-
ture should not drop below the operating
MINIMUM AVERAGE WATER TEMPERATURE [°C]
Ambient wet bulb temperature
22
4880950_03 - 1811
VED
VED
necessary to split the installation into
several circuits, each having its own
circuit breaker.
The use of very hot water could cause creak-
ing due to the thermal expansion of the
different components (plastics and metals).
This does not cause damage to the unit if
the maximum operating temperature is not
limits shown in the table below, deter-
mined by the room ambient conditions.
These limits refer to unit operation with
fan at minimum speed.
In the case of prolonged periods with the
fan switched off and cold water passing
through the coil the formation of con-
densate on the unit casing is possible.
030I 040I 130I
°C
l/h 150 150 150
l/h 1500 1500 1500
l/h 50 - 50
l/h 500 - 500
530I 540I 532I
°C
l/h 300 300 300
l/h 3000 3000 3000
l/h - - 200
l/h - - 2000
21 23
15 3 3
17 3 3
19 3 3
21 6 5
23 - 8
140I 230I 240I
65
150 150 150
1500 1500 1500
- 50 -
- 500 -
541I 730I 740I
65
300 300 300
3000 4500 4500
100 - -
1500 - -
exceeded.
In this case the installation of the 3 way
valve accessory is recommended.
Ambient dry bulb temperature
25 27
3 3
3 3
3 3
4 3
7 6
330I 340I
300 400
3000 4000
100 -
1000 -
732I 741I
300 300
4500 4500
300 300
2500 3000
29 31
3 3
3 3
3 3
3 3
5 5