Setting Oven Controls - Kenmore 970-6784 Série Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Setting Oven Controls

Setting the Clock
Changing between 12 or 24 hour display
Setting the Clock
The CLOCK
pad is used to set the clock. The clock may be set for 12 or 24 hour time of
day operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the timer
in the display will flash the time of day (Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
1. Press
. "CLO" will appear in the display (Fig. 2).
2. Press
"CLO" will appear in the display. Press
disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold
for 6 seconds (Fig. 3). While holding the
pad down the current time of day will remain and "CLO" will
disappear from the display (Fig. 4). CONTINUE holding the pad
until a beep is heard.
2. The display will show either "12h"(Fig. 5) or "24h"(Fig. 6).
3. Press
to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Fig. 5) or "24h" (Fig.
6).
4. Press
to accept the desired change or press
reject the change.
5. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
Using the Air Guard™ feature
Your appliance is equipped with a catalytic oven exhaust cleaner that may be turned on during any active cooking process.
This feature helps remove smoke and eliminates 85% of the odors generated when using your oven.
If you wish to have Air Guard™ clean the oven exhaust once cooking has started, press the
Note: The Air Guard™ indicator light will glow anytime the Air Guard™ is active. Air Guard will turn on and cannot be
manually turned off during the Self-cleaning cycle.
pads to set the time of day to 1:30 (Fig. 3).
. "CLO" will
to
13
PRESS
for 6 seconds
or
key.
Fig. 1
DISPLAY
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6

Publicité

Chapitres

Table des Matières
loading

Table des Matières