Nikon P-TACTICAL SUPERDOT Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

„ Mount height options
You can change the mount height using the included spacers.
Four options are available. The heights (in millimeters) on this page refer to distance from the center of the red dot image to the base surface height of the firearm.
• The mount is directly attached to the body (same as 1) at the time of purchase.
• To change the mount height:
- Use the included hex key to loosen the four screws on the bottom of the body.
- Choose the height from the options below.
- Firmly tighten the screws using the hex key. Use short screws for (a) and long screws for (b) in the illustrations.
Notice:
Make sure to use the specified combination of the body, mount, spacer(s), and screws as described below. If you fail to observe this precaution, the sight may
detach, causing accidents or other injuries.
1 Body + mount: 0.8 in. (21 mm)
(a)
2 Body + low-spacer + mount:
0.9 in. (24 mm)
(b)
En
Fr
De
Se
Ru
3 Body + high-spacer + mount:
Fi
1.5 in. (37 mm)
Cz
(b)
(a)
4 Body + low-spacer + high-spacer
+ mount: 1.6 in. (40 mm)
(a)
(b)
En
Fr
11

Publicité

Table des Matières
loading

Table des Matières