Nikon P-TACTICAL SUPERDOT Mode D'emploi page 10

Mounting the sight
En
The P-TACTICAL SUPERDOT can be mounted on a Picatinny rail. You can change the mount height (four options available) using the included spacers. For more
information, see the next page.
Fr
CAUTION
• Make sure the firearm is unloaded. Use safe firearm handling practices at all times.
• Be sure to allow several inches of clearance between the sight's eyepiece and your eye to avoid injury due to recoil.
De
1. Use the included hex key to loosen the hex bolt.
Se
2. Slide the sight on the Picatinny rail.
3. Attach the mounting bracket as described in the illustration.
4. Tighten the hex bolt with the tightening torque of 15 to 20 lbf·in (1.7 to 2.3
Ru
N·m).
Fi
Cz
Notice:
• If you fail to mount the sight properly, the sight may detach, causing accidents or other injuries.
• The bolt may become loose due to recoil. Check the position of the tightness guide mark on the hex bolt before using the sight. If the position of the mark has
changed, tighten the bolt again.
10
En
Fr
Tightness guide mark
Mounting
bracket
Picatinny rail
Make sure that the pointed edge of the
mounting bracket is at the bottom.
Dot sight
Hex bolt