Medela Apgar Mode D'emploi page 6

7. Checking the time
If you wish to check the time of the internal watch in the Apgar
Timer proceed as follows:
– Push the birth time retrieval button two times and exact time in
hours and minutes will appear.
– Push the Start/stop button.
8. Adjusting the time
The time on the internal clock can be set as follows:
1. Make sure there is no time visible on the Apgar Timer.
2. Push the birth time and start/stop button simultaneously.
A black dot will appear behind the first digit.
3. Push the birth time retrieval button until the correct number
appears in the first digit.
4. Push the Start/stop button, the back dot will jump to the sec-
ond digit. Again push the birth time retrieval button until correct
number appears in the second digit.
5. Follow the same steps to correct the third and fourth digit.
6. Get out of the time adjusting mode by pushing the Start/stop
button.
If you enter the time adjusting mode and do not change any digits,
the original time will continue to run after you exit out of this mode.
Cleaning
VII
General notes
The internal hospital directives take precedence. Wear suitable gloves for
cleaning/disinfection
– Switch off the device.
– The outside surfaces can be cleaned with a damp cloth.
– Cleaning or disinfecting agents should not be used in concentrated
form!
Surface cleaning materials
We recommend: Perform (conc. 1%, two 8-litre bags), Schülke & Mayr
Do not use:
EN
.
Terralin (conc. 2%), Schülke & Mayr
6