Sennheiser System 2015 Notice D'emploi page 43

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ACCESS
Important notes:
If the squelch threshold is adjusted too high, the transmission range will
be reduced. Therefore, always adjust the squelch threshold to the lowest
possible setting.
When in the setting mode of the "SQELCH" menu, pressing the
(DOWN) for more than three seconds will switch off the squelch. "SQ.OFF"
appears on the display. If no RF signal is being received, hissing noise will
occur. This setting is for test purposes only.
Releasing channels for the user
Transmitter and receiver have nine channel banks with up to 20 switchable
channels each. Via the "ACCESS" menu, you can release the channels to be
accessed by the user. For multi-channel operation, only release the channels
in one channel bank and only use the channel banks "1" to "8" since these
accommodate fixed preset frequencies which are intermodulation-free.
After you have changed into the setting mode of the menu, only the channels
that have not yet been released are displayed.
To delete all previous channel releases:
Select "ERASE" and confirm your selection by pressing the
previous channel releases are deleted and all channels can now be
released again.
Releasing channels:
Use the
/
rocker button (UP/DOWN) to select the channel to be
released.
(By briefly pressing the button, the display jumps either forwards or
backwards to the next channel; by holding down the button, the display
cycles continuously.)
Note:
You can display the frequency stored in the selected channel. To do so,
press the
SET
button and the
Release the selected channel by briefly pressing the
channel can now be accessed by the user. "ACCESS" appears on the
button (UP) simultaneously.
button
SET
button. The
SET
button. The
43

Publicité

Chapitres

Table des Matières
loading

Table des Matières