Color Marking Of Receivers - Sennheiser System 2015 Notice D'emploi

RESET
µ
¸
To enter a name, proceed as follows:
After you have changed into the setting mode of the menu, the first segment
starts flashing on the display.
Use the / rocker button (UP/DOWN) to select a character. By briefly
pressing the button, the display jumps either forwards or backwards to
the next character. If you hold down the button, the display starts cycling
continuously.
Press the SET button to change to the next segment.
Have you entered the name completely? Press the
your setting and to return to the top menu level.
Loading the factory-preset default settings
Via the "RESET" menu, you can load the factory-preset default settings. After
the reset, the unit is restarted and "SETUP" appears on the display.

Color marking of receivers

For integrative teaching with several children with hearing problems, it is
advantageous if the children can distinguish their receivers easily. You can
therefore replace the battery compartment cover and the front cover of the
receiver by colored ones (see "Accessories" on page 51).
Changing the front cover of the receiver
Press the two unlocking buttons
cover µ.
Insert a thin screwdriver into the small recess between the front cover and
the lower part of the housing.
Carefully lever out the front cover on both sides.
First insert the colored front cover into the recess on the upper end of the
battery compartment and then press it down onto the housing.
Close the battery compartment.
SET
¸
and open the battery compartment
button to store
45