Changing The Tines; Storage; Guarantee - Grizzly EGT 1345 Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
UK
Remove any soil and dirt residues stuck
to the tines, driveshaft, tool surface and
vents with a brush or dry cloth.
Spray or rub biodegradable oil into the
tines.
Clean soiled grips with a damp cloth
We shall not be held responsible for any
damage caused in any of the following ways:
-
Improper repair
-
Use of non-original parts
-
Use other than for the intended purpose

Changing the tines

The equipment is fitted with four plus
two cutting blades, which can be easily
changed. Both rows of cutting blades can
be inserted to the left or right of the trans-
mission (see
no. 21), as desired.
Always change both tine pairs at the
same time to avoid damage to the
tool from imbalance.
Switch the tool off, unplug it and
wait for the tines to stop turning.
1. Place the equipment on the
ground with the wheels pointing
upwards.
2. Undo the Allen screw and self-
locking nut (22) on the row of
cutting blades (11).
3. Take off the cutting blades from
the drive shaft (23).
4. Clean the drive shaft with bio oil.
5. Push the new row of cutting
blades onto the drive shaft such
that the holes on the blade axis
are lined up with the holes on
the drive shaft.
6. Push the Allen screw through
the hole and screw on a new
90
self-locking nut (included in the
delivery contents with a new
cutting blade).

Storage

Leave the motor to cool down before
you put the tool into a closed space.
Keep the tool clean, dry and out of the
reach of children.
Do not wrap the equipment in plastic
bags as damp could form.
Loosen the hand wheel nuts (16)
and fold the handle bars down so
the equipment takes up less space.
Make sure that the cable does
not become jammed.
Do not use the tool with the han-
dle folded closed.

Guarantee

We grant a 24-month warranty for this
appliance. Industrial use will invalidate
the guarantee.
Damage due to natural wear and tear,
overload or incorrect use is excluded
from the guarantee. Certain compo-
nents are subject to normal wear and
tear and are excluded from the guaran-
tee. These include in particular: Tines.
Furthermore, the prerequisite for guar-
antee services is that the references
indicated in the operating instructions
regarding cleaning and maintenance
have been adhered to.
Damage, which has been caused from
material or manufacturing faults, will be
made good free of charge, by replace-
ment delivery or repair.
This requires that the appliance is re-
turned to our service center undisman-

Publicité

Table des Matières
loading

Table des Matières