Changing The Rotation Direction; Emptying The Collector Box; Overload Protection; Restart Prevention - Grizzly GHS 2842 B Traduction De La Notice D'utilisation Originale

GB

Changing the rotation direction

The rotation direction can be
changed.
• Push back the operating mode
selection switch (
turn the operating mode selection
switch to the left.
The operating mode selection
switch does not lock into place.
1
Jammed chopping material is released.
The direction of rotation is to be changed
only until the chopping material is re-
leased.

Emptying the collector box

Do not leave it until too late to
empty the collector box. Remem-
ber that the collector box fi lls un-
evenly under the ejector opening.
1. Switch the shredder off .
2. Unlock the collector box (
placing the safety switch (
OFF position.
3. Remove the collector box (
the chassis (
A
4. Make sure that the area around the
safety switch (
chippings before you reattach the col-
lector box
( 11).
A
5. Reattach the collector box and place
the safety switch in the ON position.
82
2) lock and
A
2
11) by
A
10) in the
A
11) from
A
9) and empty it.
10) is free of wood
A

Overload protection

In the event of overload, e.g. due to branches
that are too thick, the equipment automatically
switches off .

Restart prevention

After switching off automatically as a result of
overload, the equipment will not restart auto-
matically.
To switch back on, start by turning the operat-
ing mode selection switch (
position.
Press the reset switch (
Switch the device back on.

Working methods

General working instructions

Keep enough distance to the shred-
der since long branches can be
spun off while being drawn into the
shredder.
Wear ear and eye protection
Wear hand protection
• For safety reasons, the shredder will not
operate without a correctly attached col-
lector box (
A
• Keep hold of branches while feeding them
into the shredder until they are automati-
cally drawn in.
• Be aware of the possible intake speed of
the cutter and do not overload the equip-
ment.
• Keep to the working speed of the shredder
and do not overload it.
• To protect the shredder from clogging,
shred wilted garden waste that has been
left for a few days and shred thin twigs al-
ternately with branches.
2) to the "OFF"
A
1).
A
11).