Pentair Flotec HYDROBLASTER 2.5 V Notice D'utilisation page 20

EN
PUMP
NO PUMP OUTPUT
1. Check pump chamber.
2. Check suction hose.
3. Measure suction and
discharge head.
4. Check engine.
1
LOW PUMP OUTPUT
1. Check suction hose.
2. Check discharge hose.
3. Measure suction and
discharge head.
4. Check engine.
18
POSSIBLE CAUSE
Pump not primed.
Hose collapsed, cut or punctured.
Strainer not completely underwater.
Air leak at connector.
Strainer clogged.
Excessive head.
Engine lacks power.
POSSIBLE CAUSE
Hose collapsed, damaged, too long, or
diameter too small.
Air leak at connector.
Strainer clogged.
Hose damaged, too long, or diameter
too small.
Marginal head.
Engine lacks power.
CORRECTION
Prime the pump (p. 12).
Replace suction hose (p. 11).
Sink the strainer and the end of a suction hose completely
underwater.
Replace sealing washer if missing or damaged. Tighten hose
connector and clamp (p. 11, 12).
Clean debris from strainer.
Relocate pump and/or hoses to reduce head (p. 10).
See page 21
CORRECTION
Replace suction hose (p. 10).
Replace sealing washer if missing or damaged. Tighten hose
connector and clamp (p. 11, 12).
Clean debris from strainer.
Replace discharge hose (p. 11).
Relocate pump and/or hoses to reduce head (p. 10).
See page 21.
ORIGINAL INSTRUCTIONS