Pentair Flotec HYDROBLASTER 2.5 V Notice D'utilisation page 15

WASHING SEDIMENT CUP
(First check fuel tank for fuel, if having, drain the fuel in the fuel tank completely.)
1. Remove the fuel sediment cup and O-ring.
2. Wash the sediment cup and O-ring in nonflammable solvent, and dry them thoroughly.
3. Place the O-ring in the fuel valve, and install the sediment cup. Tighten the sediment cup securely.
4. Move the fuel valve to the ON position, and check for leaks. Replace the O-ring if there is any leakage
SPARK PLUG
Recommended spark plugs: E6RTC or other equivalents.
NOTICE: An incorrect spark plug can cause engine damage
1. Disconnect the spark plug cap, and remove any dirt from around the spark plug area.
2. Remove the spark plug with a spark plug wrench.
Spark plug socket
3. Inspect the spark plug. Replace it if the electrodes are worn, or if the insulator is cracked or chipped. The gap
should be 0.028 -0.031 in (0.70 - 0.80 mm). Correct the gap, if necessary,
4. Install the spark plug carefully, by hand, to avoid cross-threading.
5. After the spark plug seats, tighten with a spark plug wrench to compress the water.
If reinstalling the used spark plug tighten 1/8 - 1/4 turn after the spark plug seats.
If installing a new spark plug, tighten 1/2 turn after the spark plug seats.
6. Assemble spark plug.
13
O -ring
Sediment cup
EN
ORIGINAL INSTRUCTIONS