Pentair Flotec HYDROBLASTER 2.5 V Notice D'utilisation page 14

EN
Engine oil capacities: 0.35 L
4) Assembling oil dipstick and screwing down
Recommended oil:
Use 4-stroke automotive detergent oil.
We recommend that you use API SERVICE Category SE or SF oil or equivalent to SG grade SAE 10W-30.
You can use this brand oil if your area temperature list within some brand oil temperature range
MAINTAINING AIR CLEANER
A dirty air filter will restrict air flow to the carburetor, reducing engine performance.
If you operate the engine in very dusty areas, clean the air filter more often than specified in the MAINTENANCE SCHE-
DULE
NOTICE: Operating the engine without element or with a damaged element will allow dirt to enter the engine, causing
rapid engine wear.
AIR CLEANER
1) Screw off air cleaner bolt and remove the cover.
2) Remove foam element
3) Check element and renew if damaged.
-Wash foam element:
-Wash the cover and filter in warm, soapy water, rinse, and allow drying thoroughly.
-Or clean in nonflammable solvent and allow drying. Dip in clean engine oil, and then squeeze out all excess
oil.
-Empty the used oil from the air cleaner case, wash out any accumulated dirt with nonflammable solvent,
and dry the case.
4) Clean the air cleaner l, cover and rubber gasket, preventing dust entering into carburetor.
5) Reassemble the foam element, paying attention to rubber gasket underneath the element.
6) Reassemble the air cleaner, and tighten the wing nut securely.
.Nut M6
Air cleaner elbow
12
Support plate
Element
Environment temperature
Cover Locking nut
ORIGINAL INSTRUCTIONS