Stationary Use; Tips And Tricks - Parkside PBS 900 B1 Instructions D'utilisation Et Consignes De Sécurité

Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 180
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) ––
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 320
Preselected rotation
speed
Softwood
60
high (5–6)
Hardwood
60
high (5–6)
chipboard
60
high (5–6)
Removing paint /
varnish
60
high (5–6)
Sanding varnish
150
low (1–2)
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 120
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed

Stationary use

Set the speed using the belt speed wheel
Turn the power tool as shown in figure E and
place on a sturdy worktop.
Attach two screw clamps
as shown and tighten.

Tips and tricks

Q
N ever use the same sanding belt to sand wood
and metal.
W orn or ripped sanding belts can damage
the workpiece. Change sanding belts at the
appropriate time.
K eep the sanding belt properly tensioned so
that it does not hang down too much and
become unusable due to nicks, creases etc.
Operation
Rust removal
40
medium / high (3–4)
Plastic
120
low / medium (2–3)
Non-ferrous metals
(e.g. aluminium)
80
medium / high (3–4)
.
1
to the power tool
12
GB 41