Aprimatic T11 Instructions Pour L'installation page 11

Safety recommendations
• The manufacturer's instructions must be strictly observed.
• The installer must check the installation and the correct functioning of the device.
• The product must not be used incorrectly or for purposes other than those
envisaged.
• Do not tamper with or modify the product in any way.
• Always use original spare parts.
• Cordon off the working area to prevent the access to unauthorised people.
• Ensure that the working area is clear of obstacles and the fl oor is not slippery.
• All equipment used must be in good working condition.
• Do not work in environments not suffi ciently lit or unsafe.
• Keep unauthorised people clear of the intervention area.
• Do not leave the intervention area unattended.
Purpose of the manual
This manual has been drawn up by the manufacturer and is integral part of the
product.
The information contained herein is addressed to expert operators charged with the
installation and the extraordinary maintenance. These operators must have specifi c
knowledge and must be able to perform all of the interventions in a correct and safe
way. The strict observance of these instructions grants safe conditions, an effi cient
operation and a long life of the product. To prevent operations that can result in
accidents, read this manual thoroughly and obey its instructions.
Application fi eld
APRIMATIC hydraulic operators to automate swing gates.
APRIMATIC electromechanical operators combined with SAFETY CARD to automate
swing gates.
ENGLISH
Contents
1. DESCRIPTION
1.1 Block diagram of the device ...........................................................6
1.2 Technical data ................................................................................6
2. INSTALLATION
2.1 Preparation.....................................................................................6
2.2 Assembly........................................................................................6
2.3 Electrical connections ....................................................................6
3 OPERATION
3.1 Functioning tests ............................................................................7
3.2 Trimmer adjustment........................................................................7
3.3 Operation programming .................................................................7
4. FUNCTIONING CHECK
4.1 Functioning check of external devices ...........................................7
5. REMOTE CONTROL MANAGEMENT (ONLY FOR T11)
5.1 Memory test ...................................................................................8
5.2 Procedure for total deletion of the memory ...................................8
5.3 Procedure for self-learning of the fi rst remote control ....................8
5.4 Procedure for self-learning of other remote controls ......................8
5.5 Deleting a remote control ...............................................................8
6. ACCESSORIES
6.1 CA41 module .................................................................................8
6.2 16 kb or 128 kbits memory expansion module...............................8
6.3 Programming tools .......................................................................8
6.4 Safety card .....................................................................................8
6.5 Coded keypad ...............................................................................8
6.6 Badge reader ................................................................................8
5