Bronpi HYDRO Série Instructions D'installation, D'utilisation Et D'entretien page 23

The combustion is not always stable. In fact, it can be affected by the weather conditions or the outside temperature. This modifies the draw
of the equipment. For this reason, all the hydro models have a baffle plate and a draft-diverter valve in Hydrobronpi-E that controls and
improves the draw.
Smoke valve
The models Hydrobronpi-E and Hydrobronpi-E-Vision are provided with an adjustable smoke valve
with automatic opening that regulates the air draft ideally. By using the screw found in the upper
right part (when the door is opened) it is possible to position properly the smoke valve (turn right =
open the valve, turn left = close the valve). When the door is opened, regardless of its position, the
smoke valve opens automatically, avoiding the expulsion of smoke outside (see drawing D11).
Baffle plate
The baffle plate is a fundamental part for the proper operation of the equipment. It must be placed
in the right position and the thermo-stove must not be used without the baffle plate. This would
invalidate the warranty.
WARNING!
The lack of the baffle plate causes an excessive draw. This causes a fast combustion, excessive wood consumption and
the overheating of the equipment.
Due to safety reasons during the transport, the baffle plate is not assembled. You will find it inside the combustion chamber.
- In the model Hydrobronpi-E and Hydrobronpi-E-Visión, the baffle-plate is supported on the top of the heat exchanger. It must be
moved to the rear part of the equipment so that the smoke circulates between the baffle-plate and the frontal of the thermo-stove (see
drawing D12).
- In the model Hydronova-C the baffle plate must fit with the double combustion air output and, in order to avoid it falls, we must
introduce the two sheet into the two slots on the bottom part of the combustion chamber (see drawing D13).
- In the model Hydroniágara the baffle-plate is supported on the lateral exchangers and it must be totally placed on the rear part of the
boiler (see drawing D14).
D12
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D9
D13
22
D10
D11
D14
HYDRO RANGE