Ironing With Steam Blast; Pausing Operation Of The Steam Iron; Switching The Steam Iron Off; Anti-Drip System - SilverCrest SDB 2400 B2 Mode D'emploi

–
Make sure you do not turn the steam control 8
further than the
will activate the self-cleaning function (see
chapter "Self-cleaning function").
■ As soon as you hold the steam iron horizontally,
steam will come out of the sole of the iron 9.
If you set the steam regulator 8 to
■
the steam iron vertically, no steam will come out
of the sole of the iron 9.

Ironing with steam blast

The steam blast function is especially suitable for
smoothing diffi cult-to-reach parts of a garment.
1) Raise the steam iron slightly.
2) Press the steam blast button 5 for a blast of
steam.
You can also use the steam blast function to smooth
hanging textiles.
Hold the iron vertically and press the
steam blast button 5.

Pausing operation of the steam iron

CAUTION – RISK OF FIRE!
Never leave a hot steam iron unattended if it is
switched on or connected to the mains power
supply.
1) To switch off the steam iron, press and hold the
3 button or the
TEMP
until you hear a beep and the display 1 reads
"Standby" in red letters.
Or:
TEMP 2 button repeatedly until
2) Press the
you hear a beep and the display 1 reads
"Standby" in red letters.
SDB 2400 B2
setting. Otherwise, you
or hold
TEMP 2 button
Switching the steam iron off
1) Remove the power plug from the mains power
socket.
2) Empty the water tank and clean the sole of the
iron 9.
3) Place the cooled-down steam iron on the base 7.

Anti-drip system

With conventional steam irons, water can drip
from the sole of the iron 9 if the set temperature
is too low. This steam iron, however, is equipped
with a special anti-drip system (
temperatures, the steam iron automatically switches
off the steam blast function. When this happens,
a "click" can be heard. Set a suitable temperature
level. As soon as this is reached, steam production
is resumed.

Cleaning

Self-cleaning function

1) Fill the water tank to the marking MAX.
2) Insert the plug into the mains power socket.
3) To switch on the iron and set the temperature,
press the TEMP
11/MAX appears on the display 1.
4) Turn the steam control 8 to "SELFCLEAN" and
keep it in this position. For safety reasons, the
steam control 8 does not snap into this posi-
tion, as this would cause water to drip from the
sole of the iron 9 continuously.
5) Hold the steam iron horizontally over a suitable
container.
). At low
3 button repeatedly until
GB │ IE │ NI
9
│
■