Operation; Plugging In And Ironing; Steam Ironing - SilverCrest SDB 2400 B2 Mode D'emploi

Mixed fabric
(steam iron-
ing possible)
(steam iron-
ing possible)
(steam iron-
ing possible)
(steam iron-
ing possible)

Operation

Plugging in and ironing

NOTE
You can dry-iron without steam at all tempera-
tures. Steam ironing is only possible from tem-
perature level 8 and upward (
on the display 1).
│ GB │ IE │ NI
■ 8
Wool
Cotton
Denim
Linen
The automatic switch-off
is activated (see chapter
"Automatic switch-off ")
also appears
1) Insert the plug into a mains power socket.
There will be a beep and the display 1 will
read "Standby" in red letters.
CAUTION – PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing
( ), the garment may not be ironed. Ignor-
ing this warning could lead to permanent
damage to the clothing item.
2) Check the care instructions on the labels in
garments to see if they are suitable for ironing,
and at which temperature setting.
3) To switch on the iron, press the TEMP
3 repeatedly until the required temperature
level appears on the display 1 (see chapter
"Meaning of the display indicators"). Use the
TEMP 2 button to switch to a higher or
lower temperature level.
As soon as the indicator for the material type stops
fl ashing on the display 1 and a beep is heard,
the set temperature has been reached and you can
begin ironing.
NOTE
If you are ironing very dry and creased fabrics,
you can dampen the material using the spray
function. To dampen the material, press the but-
ton for the spray function 4.

Steam ironing

NOTE
The temperature level must be set at least to
level 8. Otherwise no steam will be produced.
Set the steam control 8 to the desired steam
■
setting.
–
Turn the steam control 8 towards
generate more steam.
–
Turn the steam control 8 towards
generate less steam.
button
to
to
SDB 2400 B2