Ironing Without Steam; Ironing With Steam; Steam Burst Function - SilverCrest SDBK 2400 D3 Mode D'emploi

B&3(B'DPSIEJHOHLVHQB%ERRN 6HLWH  0LWWZRFK  -XOL   

7.4 Ironing without steam

Sensitive fabrics are ironed at lower temper-
atures and without steam. In order to damp-
en them, the spray function is available.
1. Set the steam flow rate control 5 to
and set the temperature controller 19 to
MIN.
2. Fill the water tank 16 if you wish to use
the spray function.
3. Place the steam iron in the stand 12.
4. Connect the mains plug with the wall
socket.
5. Set the desired temperature using the
temperature controller 19. The tempera-
ture control lamp 14 lights up.
6. Start ironing as soon as the ironing tem-
perature has been reached 14 and the
temperature control lamp goes out.
7. Finish ironing, set the temperature con-
troller 19 to MIN and pull out the
mains plug.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 16 through the filling open-
ing in the water tank (under the lid 2).

7.5 Ironing with steam

Steam ironing requires a high temperature,
at least the temperature setting for
der to additionally dampen items of cloth-
ing, the spray function is also available.
1. Set the steam flow rate control 5 to
and set the temperature controller 19 to
MIN.
2. Fill the water tank 16.
3. Place the steam iron in the stand 12.
4. Connect the mains plug with the wall
socket
5. Set the temperature controller 19 to the
desired temperature (at least
temperature control lamp 14 lights up.
52 GB
6. As soon as the ironing temperature has
been reached and the temperature con-
trol lamp 14 goes out, adjust the steam
flow rate controller 5 to the desired
steam flow rate
ironing.
The steam will...
... start to come out as soon as you hold
the steam iron horizontal, and
... stop as soon as:
- you hold the steam iron vertical,
- you place the steam iron in the
stand|12,
- the temperature falls too low,
- the water tank is empty,
or
- you set the steam flow rate controller
5 to
.
7. Finish ironing, set the temperature con-
troller 19 to MIN, set the steam flow
rate controller 5 to
mains plug.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 16 through the filling open-
ing in the water tank (under the lid 2).

7.6 Steam burst function

The steam burst function requires a high tem-
. In or-
perature. Select a temperature setting be-
tween and MAX. For this purpose, the
water tank 16 must be at least one quarter
full.
• Press the steam burst button 4
the steam iron glides over the item of
laundry.
• Wait a few seconds before you press
the steam burst button 4
NOTE:
). The
• For smoothing items of clothing that are
hanging up, you can use the steam
burst in a vertical position.
and start
and pull out the
while
again.