Ironing Without Steam - SilverCrest SDBS 2200 A1 Mode D'emploi

Ironing without steam

NOTE
Always set the temperature control
level before you switch on the appliance. The symbols on the temperature
control
●
● ●
● ● ●
♦ Press the on/off button
button as well as the "Iron dry" indicator
NOTE
If the "Iron dry" indicator
Press this button to switch off the boiler function.
♦ Turn the temperature control
♦ The temperature indicator
As soon as the temperature indicator
been reached and you can start ironing.
♦ If the iron
catch release
from the base station
♦ After ironing, place the iron
Set the temperature control
♦ Press the on/off button
On/off button
hazards, place the connecting hose
mains plug out of the socket and press the cable retractor button
♦ To fi x the iron
into the
the iron handle
the holder
SDBS 2200 A1
correspond to the following settings:
Synthetics –
Wool, silk –
Cotton, linen –
to switch on the appliance. The indicator in the
does not light up, the boiler button
lights up while the appliance is heating up.
is fi xed to the base station
into the position. Now you can remove the iron
.
to switch off the appliance. The indicator in the
and the "Iron dry" indicator
back onto the base station
position. Then you can carry the appliance in just one hand using
if you have previously placed the connecting hose
provided (to avoid a tripping hazard).
and the steam control
lowest temperature (70 – 120°C)
medium temperature (100 – 160°C)
highest temperature (140 – 210°C)
light up.
to set the desired ironing temperature.
goes out, the set temperature has
using the catch
on the base station stand
to "MIN".
go out. To avoid tripping
in the holder
push the catch release
to the lowest
is pressed.
, push the
.
provided, pull the
.
in
13
GB
IE