Steam Ironing; Ironing With Steam Blast; Temporarily Setting The Steam Iron Down; Taking The Steam Iron Out Of Service - SilverCrest SDB 2400 A1 Mode D'emploi

2) Check the care instructions on the labels in
GB
garments to see if they are suitable for being
IE
ironed, and at which temperature setting.
3) To switch on the iron, press the TEMP
button repeatedly until the required tem-
perature level appears on the display
chapter "Meaning of the display indicators").
Use the TEMP
higher or lower temperature level.
As soon as the indicator for the material type stops
flashing on the display
set temperature has been reached and you can
begin ironing.
NOTE
If you are ironing very dry and creased fabrics,
you can dampen the material using the spray
function. To dampen the material, press the
button for the spray function

Steam ironing

NOTE
The temperature level must be set to at least level
6. Otherwise no steam can be produced.
■ Set the steam regulator
setting. As soon as you hold the steam iron
horizontally, steam will discharge from the sole
of the iron.
■ If you set the steam regulator
the steam iron vertically no steam will come out
of the sole of the iron.

Ironing with steam blast

The steam blast function is especially suitable for
smoothing difficult-to-reach parts of a garment.
1) Slightly raise the steam iron.
2) Press the steam blast button
steam.
You can also use the steam blast function to smooth
hanging textiles.
8
(see
button to change to a
and a beep is heard, the
.
to the desired steam
to or hold
for a blast of
Hold the iron vertically and press the
steam blast button
Temporarily setting the steam iron
down
CAUTION – RISK OF FIRE!
Never leave a hot steam iron unattended if it is
switched on or connected to the mains power
supply.
1) To switch off the steam iron, press and hold the
TEMP button
until you hear a beep and the display
up red and indicates OFF.
Or:
2) Press the TEMP
you hear a beep and display
and indicates OFF.

Taking the steam iron out of service

1) Remove the plug from the mains power socket.
2) Empty the water tank and clean the sole of
the iron.
3) Place the cooled-down steam iron on the
base .

Anti-drip system

With conventional steam irons it can happen that
water drips from the iron sole at low temperatures.
This steam iron, however, is equipped with a special
anti-drip system. At low temperatures the steam iron
automatically switches off the steam blast function.
When this happens, a "click" can be be heard.
Set a suitable temperature level. As soon as this is
reached, steam production is resumed.
.
or the TEMP button
lights
button repeatedly until
lights up red
SDB 2400 A1