OFFCAR STILE 700 70FRG-17R Mode D'emploi page 11

- To connect the power supply, identify the junction box inside the appliance and connect the power cable with a
standardized plug that is adequate to the power intake. Follow the instructions on the terminal clamp. Plug the
plug into a power socket that has been properly earthed in compliance with current legislation.
- Before connecting the appliance directly to the main power supply, fit a circuit breaker of adequate capacity
whose contacts have a minim distance of 3 mm.
- When the machine is operating the power supply must not deviate from the nominal supply by more than ±
10%.
- The equipment must also be part of an equipotential system whose efficiency must be tested to ensure
compliance with current regulations.
Before delivering the appliance to the user:
- check that it operates correctly,
instruct the user on how to use it.
-
2.
The appliance must be used only for the purpose for which it was designed. Any other use is improper.
During operation, supervise the appliance.
2.1 STARTING UP FOR THE FIRST TIME
Before starting up the appliance for the first time remove all the packing and thoroughly clean the protective industrial
grease from the tray and containers using this procedure:
- fill the tank to the brim with water and normal detergent, turn on heat and boil for a few minutes.
- drain the water through the drain tap and rinse the tank with plenty of clean water;
- shut off the tap and pour in frying oil above the MIN mark and below the MAX mark.
WARNING:
Old oil catches fire at a lower temperature and makes froth that tends to boil over. Remember that placing food that is too
moist and placing too much food in the fryers contributes to the formation of froth that may boil over.
CAPACITY DATA PER SINGLE BASKET
DESCRIPTION
GAS FRYER WITH 17L TANK
GAS FRYER WITH 22L TANK
2.2 SETTING
APPLIANCES WITH ELECTRIC GAS VALVE (FIG.7)
EVERYTHING
SWITCHED
The appliance has a gas valve with a 1N 230-VAC 50-Hz power supply.
- Use main switch to start up.
- Turn the knob (Fig. 8) of main switch to (1) and display C (Fig. 9) will come on.
- Open the gas stopcock behind the appliance.
- Turn the knob (Fig. 7) and press it at the 'SWITCH-ON' position and keep it pressed until the pilot flame comes
on and stays lighted (about 20 seconds).
- Turn the knob (Fig. 7) to 'OPERATION' position.
If the pilot light goes out, the valve will automatically shut off the gas flow and the main burner will then also go out.
OPERATING INSTRUCTIONS
SWITCHED OPERATION
LIGHTING THE PILOT LIGHT
LIGHTING THE MAIN BURNER
RAPID DEVICE
TANK LITERS KG. POTATOES PER BASKET
17
22
FIG. 7
11
1,9
2,5
FIG. 8