Güde GTB 16/5R Traduction Du Mode D'emploi D'origine page 28

ENGLISH
24
Inspection and maintenance plan
Regular servicing period
Check the safety equipment
Check the V-belt and tighten
it if necessary
6
Apply a thin layer of oil on
the pillar and the bench
Apply some fat on the angle
drift
Remove drill cuttings and
metal chips from the device
Provide appropriate servicing upon the earlier of the following: in the given month or after the specifi ed hours of
operation have expired.
Failure removal
Failures
Engine not
starting
Drill is turning
unevenly
Before Whenever
any start- the device
up is put into
operation


Causes
The micro switch in the belt housing prevents starting if
the housing is not closed properly.
The choke is not fi tted properly on the angle drift.
After 1 After 3
months months
20
Hours of Hours of
operation operation


GTB 16/5R | GTB 16/12RL
After 6 After 12
months months
50 100 Hours 300 Hours
of opera- of opera-
tion tion

Removal
Close the belt housing
properly!
Push in the chuck by light
tapping.