MPF Black Beat Mode D'emploi page 65

Step 10
Connect the heart rate measurement wire (15) to the computer. The heart rate measurement
helps you during your workout and displays the heart rate differences.
Step 11
Check whether all screws and nuts are firmly secured. The home trainer is now ready for use.
Step 5
Loosen adjusting knob (18). Slide
the saddle pillar (9) onto the main
frame (1). Align the holes in the
saddle pillar with the holes in the
main frame (1). Secure firmly with
adjusting knob (18).
Step 6
Remove three nuts (11) and
washers (7) from the saddle (8).
Slide the saddle onto the saddle
pillar and secure with three nuts
and washers.
Step 7
Attach the handlebar post (25) with the
mounting bracket (32) and secure it with the
screws (28A), washers (33) and L-clip. Slide
the foam grips (17) onto the handlebar post
(25) Moisten the inside with water and soap,
if necessary.
Step 8
Slide pedal (22L), marked with an L, onto
the left-hand pedal spindle. Slide pedal
(22R) onto the right-hand spindle (seen from
the position of the user). Secure the pedals
with the supplied wrench.
Step 9
Attach the computer to the handlebar post.
Connect the computer cable (19) to the
computer.
65