Cleaning And Maintenance; C Le A N I Ng The Fil Ter And The Port Af Il T Er; C Le A N I Ng The D Rip T Ray Wit H Drip Grid - SOLIS BARISTA PERFETTA PLUS 1170 Mode D'emploi

Masquer les pouces Voir aussi pour BARISTA PERFETTA PLUS 1170:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

C L E A N IN G A ND M AI NT E NAN C E
s
ATTENTION: Every time before cleaning, switch off the appliance, disconnect the
mains plug from the power outlet and let the appliance cool down.
Do not use abrasive or aggressive cleaning agents, rough sponges or cloths as they
might scratch the surface.
ATTENTION: Never immerse the espresso machine casing, the power cord or the
power plug in water or other liquids or allow the parts to come into contact with
them!
GB
NOTE: The espresso machine parts and accessories are not dishwasher safe.

C LE A N I NG THE FIL TER AND THE PORT AF IL T ER

Use the small needle of the cleaning tool to clean the hole of the dual wall filters.
The pin is not intended for the single wall filters.
Up to under the handle of the portafilter, place the dirty portafilter and the filter
in a container with mild detergent and hot water.
C LE A N I NG THE ST EAM IN G NOZZL E O F T HE ST EAM / H OT
W A T E R W A N D
Unscrew the steam nozzle from the steam / hot water wand. Rinse the steam
nozzle carefully in warm water and then re-rinse it with clear water.
Should the nozzle be blocked, insert the big needle of the cleaning tool into the
opening of the nozzle. If the nozzle still is clogged, first place the nozzle in a glass
of hot water, then use the needle again to remove the blockage.
Screw the nozzle back onto the steam/hot water wand.
C LE A N I NG THE CA SING , THE CUP T RAY
AN D TH E W ATER TAN K
Clean the casing, the cup tray and the water tank with a soft, slightly moist cloth,
then dry it with a dry cloth.

C LE A N I NG THE D RIP T RAY WIT H DRIP GRID

Remove, empty and clean the drip tray with the drip grid at regular intervals but
every time it is full and the red float gauge is visible between the drip grid.
138
Remove the drip grid and pull the drip tray out to the front. Hand wash the
drip tray and the drip grid with mild detergent and warm water. Do not use any
aggressive cleaning agents or scouring sponges. Rinse the tray and the grid with
clear water and carefully dry both parts.
CAUTION: Drip tray and drip grid are not dishwasher safe.
Reinsert the drip tray and place the grid back on the drip tray.
CLEANING THE BREWING HEAD AND THE BREWING GROUP
– PERFORMING THE CLEANING CYCLE
If the appliance emits a cleaning alarm (
red and the
button is lit white), you will have to clean the brewing head with
the included rubber insert (Y) and a SOLITABS tablet to thoroughly remove coffee
grease and other residues.
Proceed as following:
1. First empty the drip tray and place it back into the
appliance. Fill the water tank up to the Max-marking
with water. Place a container under the brewing group.
2. Now, place one of the filters for 2 cups in the porta-
filter. Place the rubber insert (Y) in the filter and put a
SOLITABS cleaning tablet on top. Insert the portafilter
into the brewing group.
3. Now press the Prog. button, the Prog. button and the
4. Now press the
button to start the automatic cleaning cycle.
5. During the automatic cleaning cycle, the
cleaning cycle lasts less than 10 minutes, approx. 500 ml of water are led through
the brewing group. During this time the buttons cannot be operated.
6. As soon as the cleaning is finished, two signals are sounded and both coffee
buttons constantly light up white, the other buttons are not lit up.
7. Remove the portafilter from the brewing group. Rinse the portafilter, the rubber
insert, the filter and the drip tray with warm water. Re-stow the rubber insert for
the next use.
button alternately flashes white and
button flash red.
and Prog. buttons flash rapidly. The
139
GB

Publicité

Table des Matières
loading

Table des Matières