SOLIS BARISTA PERFETTA PLUS 1170 Mode D'emploi page 72

Masquer les pouces Voir aussi pour BARISTA PERFETTA PLUS 1170:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

C LE A N I NG C YC LE HAS TO BE P ERF ORMED :
BU TTON FLAS HES WHIT E / RED
For the cleaning alarm, the
alternately flashes white and red,
the
button lights up white.
Please refer to page 139 for information on how to perform the cleaning cycle.
DES CALI N G C Y CLE HAS TO BE PERFO RMED :
B UTT ON F LASH ES RED
GB
For the descaling alarm, the
both coffee buttons light up white.
Please refer to pages 140 –141 for information on how to perform the descaling
cycle.
ATTENTION: It is possible that multiple alarm signals are displayed at the same time.
In such a case, each alarm should be fixed individually according to the description
in the manual, until all alarms have gone out and both coffee buttons constantly
light up white again.
AL ARM S I GNA L
"CO FF E E D I SP ENSIN G N OT POSSIBL E":
B O T H C O FFEE BUT TONS FL ASH TW ICE
AN D TW O S IGNA LS ARE SOU ND ED
Possible reasons and fixes:
When water tank is empty the machine will stop to brew coffee or pouring hot water
or steaming after a few seconds.
Fill the water tank up to the Max marking and press one of the two coffee buttons.
The two coffee buttons constantly light up white if the appliance is ready for use
again.
IMPORTANT: Please always fill the tank with water after the filter has been installed
and start the settings and the rinse cycle for the new filter as described on page 127.
Coffee dispensing is not possible because the coffee is ground too finely:
The pump stops if no coffee is dispensed after 60 seconds and two signals are
sounded.
Change out the ground coffee in the filter, the coffee powder has to be less finely
ground.
142
button
button flashes red,
T R O U B L ESH O O TI N G
s
Problem
Possible cause
Machine doesn't
Machine is not switched
work.
on or power plug is not
plugged in.
Short circuit / power out­
let is without power.
The espresso machine is
faulty.
Coffee does not
Water tank is empty.
or only slowly run
The water tank is not
out of the porta-
installed correctly.
filter.
Coffee is ground too
finely.
Too much coffee in filter.
Ground coffee is tamped
too strongly.
Filter is clogged up.
The machine is set to
steam / hot water mode,
meaning the steam
button has been pressed
(the steam button is
lighting up or blinking
and the coffee buttons
and
are not
lighting up).
The steam / hot water
control is open.
The espresso machine is
faulty.
Coffee runs
Coffee is ground too
through too
coarsely.
quickly.
Too little coffee in filter.
Ground coffee is not
tamped strong enough.
Solution
Make sure that the power plug is
plugged in, that the ON/OFF button has
been pressed and that both coffee but­
tons light up white.
Check the power supply.
Contact Solis service center.
Fill water tank.
Correctly install the water tank.
Ensure appropriate degree of grinding.
Ensure appropriate amount.
Tamp ground coffee less strongly.
Clean the filters.
Press one of the coffee buttons and wait
for the two coffee buttons to constantly
light up white.
Turn off the control.
Contact Solis service center.
Ensure appropriate degree of grinding.
Ensure appropriate amount.
Tamp ground coffee more strongly.
143
GB

Publicité

Table des Matières
loading

Table des Matières