Kenwood IM250 Série Mode D'emploi page 5

FROM IMMEDIATELY FREEZING ON
THE INSIDE OF THE BOWL.
6 Use the chute and pour the ice-
cream or sorbet mix into the freezer
bowl.
G
When pouring mixture into the bowl,
always stop at least 2.5cm from the
top, as the mixture will increase in
volume during freezing.
7 Allow the mixture to churn until
frozen or the desired consistency is
reached, this can take up to 15 to
30 minutes, but most recipes will be
ready in less time.
important
G
Do not stop and start the machine
during the freezing process, as the
mixture may freeze in contact with
the bowl and prevent movement of
the paddle.
G
To avoid overheating the motor, the
direction of rotation will change if the
mixture becomes too thick. If the
direction of rotation continues to
change, stop the machine as the
mixture is ready.
G
In the unlikely event of the motor
overheating, a safety cut out will
operate causing the motor to stop.
If this happens, switch off, unplug
the machine and allow the power
unit to cool.
8 Switch off, remove the power unit/lid
by turning anti-clockwise. The ice
cream is ready to serve.
G
The ice cream produced should be a
soft spoonable type. This can be
transferred to a separate container
for storage in the freezer or if you
wish to firm the ice cream before
eating.
important
G
Do not use metal utensils to
remove mix from the bowl.
G
Do not remove the freezer bowl
from the freezer until ready to make
ice cream.
hints
G
We suggest that you keep the
freezer bowl in the freezer so that it
is ready for use. Place in a plastic
bag before freezing. Freeze the bowl
in the upright position.
G
Always make sure the freezer bowl is
thoroughly dry before placing in the
freezer.
G
Do not puncture or heat the freezer
bowl.
G
The freezer bowl should be placed in
a freezer that is operating at a
temperature of -18°C or below for
24 hours before use.
G
For best results always refrigerate
the ingredients before making ice
cream.
G
The addition of alcohol to recipes
inhibits the freezing process.
cleaning
G
Always switch off, unplug and
dismantle before cleaning.
G
Never put the power unit in water or
let the cord or plug get wet.
G
Don't wash parts in the dishwasher
freezer bowl
G
Remove the freezer bowl from the
outer bowl.
G
Allow the freezer bowl to reach room
temperature before attempting to
clean.
1 Wash the inside of the bowl, then
dry thoroughly. Do not immerse in
water.
paddle, outer bowl
G
Remove the paddle from the power
unit.
1 Wash then dry thoroughly.
lid
G
Press the power unit release lever to
separate the lid from the power unit
.
1 Wash the lid then dry thoroughly.
power unit
G
Wipe with a damp cloth, then dry.
3