Emc Guidance - Soehnle CONNECT 400 Mode D'emploi

EMC GUIDANCE

1) This product needs special precautions regarding EMC and needs to be
installed and put into service according to the EMC information provided,
and this unit can be affected by portable and mobile RF communications
equipment.
2) Do not use a mobile phone or other devices that emit electromagnetic
fields, near the unit. This may result in incorrect operation of the unit.
3) Caution: This unit has been thoroughly tested and inspected to assure
proper performance and operation!
4) Caution: This machine should not be used adjacent to or stacked with
other equipment and that if adjacent or stacked use is necessary, this ma-
chine should be observed to verify normal operation in the configuration
in which it will be used.
Table 1
Guidance and manufacturer's declaration – electromagnetic emissions
The device is intended for use in the electromagnetic environment specified below. The
customer or the user of the device should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
144
Compliance
Group 1
Class B
not applicable
not applicable
Electromagnetic
environment - guidance
The device uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
The device is suitable for use in all estab-
lishments, other than domestic and those
directly connected to the public low-vol-
tage power supply network that supplies
buildings used for domestic purposes.