Güde OLFREI Traduction Du Mode D'emploi D'origine page 14

Always have the faulty cables and plugs
repaired by a specialist. Always use the unit on
a connection equipped with faulty current
protections switch (FI).
Indirect electrical contact Injuries
conductive parts of open electrical or
defective structural parts
Always unplug when maintaining.
Operate only with the FI switch.
Insufficient local lighting
Insufficient local lighting is a high safety
hazard.
Always provide for sufficient lighting when
working with the unit.
Disposal
Disposal instructions are illustrated in the form
of pictograms on the device or packaging.
Description of the pictograms is given in
"Identification" chapter.
Disposal of transport packaging
Packaging protects the device against damage
during transport. Packaging materials are
usually selected according to their effect on
environment and disposal methods and can
therefore be recycled.
Returning of the packaging back to circulation
saves resources and costs for packaging
disposal.
Parts of the packaging (e.g. foil, styropor) may
be dangerous for children. Risk of suffocation!
Keep these parts of the packaging out of reach
of children and dispose as soon as possible.
Operator Requirement
The operator shall read the instruction manual
carefully before using the unit.
Qualification
No special qualification is required for use of the
unit except for detailed direction by a professional.
Minimum Age
Only persons above 16 years of age are
allowed to work with the unit. .
Exempted from the provision is the use of the
juvenile trainees if they work in the course of
their professional training with an aim to obtain
the skill under trainer supervision.
Training
Use of the unit requires adequate lesson by a
professional or the use of the manual only.
Special training is not required.
Transportation and Storage
•
For long-time storage, the unit should be cleaned
thoroughly and put on storage in the way
preventing admission of unauthorised persons.
•
The compressor should be never stored or
by
transported lying or under the pressure!
•
The pressure in the air tank may be decreased at
cooling the compressed air. .
Assembly/Initial operation
If the compressor delivered without wheels they
should be mounted on with a screwdriver – see Fig. 4
The sequence of screws, nuts and washers is shown
in Fig. 4. It is also possible to screw a rubber bottom
end on. Fixing material – screws, nuts etc. is included
in the delivery.
Operation
Unplug the compressor before any adjustment
or maintenance.
Working pressure control
•
It is easy to set up the pressure. Turn the rotary
knob (2) in direction, the pressure will increase, It
will decrease of the knob is turn in – direction.
The pressure may be fixed tightening the
counter-ring.
• There is a safety valve on the compressor, by
which the pressure may be decreased in case
of overpressure. The pressure in the air tank
may be decreased pulling the valve ring (10).
CAUTION:
Take care about required quantity to be supplied by
your pneumatic tool the pressure only is not decisive
for perfect or sufficient operation. Switching on the
compressor after long shutdown without using it is
normal!
Any repairs, if necessary should be done by skilled
authorised personnel only.
Inspections and Maintenance
Unplug before any work any work on the unit. Before
shutting down the compressor for a longer time, it is
essential to drop some oil on the air filter liner to
ensure lubrication for restart.
•
Use s wet cloth to clean plastic parts. Do not use
detergents, solvents and pointed tools either.
•
Dust vents and movable parts with a soft brush
after every use.
Oil any movable metal parts regularly
Inspections and Maintenance
Safety Instructions
14