7. Error handling and troubleshooting
Problem
• The machine is
• Mains plug is incorrectly inserted
without function or
into the mains socket.
malfunctioning.
• Mains plug is defective.
• Mains fuse was tripped.
• The machine is
• The driving disc or abrasive is not
too noisy.
attached correctly.
• Machine vibration
• The material or substrate to be
is excessive.
processed is too hard.
• The machine
• Clogged extraction system.
produces too much
dust.
• Dust bag in the industrial extractor
is full.
• Insufficient
extraction perfor-
• Kink in the extractor hose.
mance.
• The extraction openings in the
driving disc and sanding disc are not
congruent.
• Too much of
• The grit size of the abrasive is too
the substrate is
large.
abraded.
• The entire sand-
• The abrasive grit is incorrect or too
ing area displays a
large and/or the incorrect type of
bad or sub-optimal
abrasive is being used.
surface quality.
• The material or substrate to be pro-
cessed is not yet completely dry.
• The material or substrate to be
processed is too soft and/or has a very
high filler content.
• Striae in the
• Driving disc not flat on the substrate.
sanded area.
• The material or substrate to be
processed is too soft.
• Deteriorating
• Reverse of the abrasive is worn.
adhesion of
the abrasive or
• Hook & loop layer on the driving disc
the driving disc
is worn.
accessory.
12 EN
possible causes
remediation
• Check the plug connection; insert
the mains plug correctly into the
mains socket.
• Check the mains fuse.
• Contact the MENZER repair service.
• Attach the driving disc and abrasive
securely and centrically.
• Change the rotational speed.
• Choose another abrasive. Read our
abrasive overviews or seek advice.
• Contact the MENZER repair service.
• Clean the extraction system.
• Empty the dust bag.
• Remove the kink.
• Position the extraction openings
congruently.
• Choose a smaller grit size.
• Choose a smaller grit size and/or a
different type of abrasive. Read our
abrasive overviews or seek advice.
• Read the data sheets and processing
instructions provided by the manufac-
turer of the material to be processed.
• Position the driving disc flat on the
substrate.
• Choose a smaller grit size.
• Replace the abrasive.
• Replace the driving disc.
• Use MENZER pad saver.