Sanding Walls And Ceilings; Changing The Sanding Disc; Storage; Maintenance - Menzer TBS 225 PRO Mode D'emploi

Setting the rotation speed:
The rotation speed is fully variable and can be adjusted as required using the rotation speed controller. This
is also possible while the machine is in operation. A higher rotation speed allows for a higher rate of surface

3.2.3 Sanding walls and ceilings

both hands at all times.
scratches and uneven areas in the surface and may also cause damage to the tool itself. It is best to move
too long in one area can leave behind unwanted marks.
3.2.4 Removable nose section
The sander is equipped with a removable nose section which allows you to sand right up to the edge of a

3.2.5 Changing the sanding disc

Disconnect the sander from the power supply before changing the sanding disc. Peel the used sanding disc
from the hook & loop pad and place the new disc on it in a centred position. The sanding disc will be held
in place by the hook & loop pad. Choose a suitable grit for the job at hand. Be aware that if the grit is too
wear out the abrasive.

4. STORAGE

The machine must not be exposed to wet or damp storage conditions. The power cable must be discon-
nected from the power source before storage. It must not be used to hang the tool. Always store the sander
in its carrying case and keep it out of the reach of children.

5. MAINTENANCE

All air passages and joints must be kept free of dirt and cleaned with compressed air after each use of the
Never use solvents for cleaning the machine.
6 EN

5.1 TROUBLESHOOTING

Problem Possible cause
1. The machine produces too The driving disc or the abrasive
much noise.
may not be correctly fastened.
2. The machine is vibrating too
heavily.
The machine produces too much 1. The suction tube is clogged.
dust. 2. The dust bag in the industrial
vacuum cleaner is full.
The machine is running but does You may be pressing the driving
disc to the surface too hard.
speed.

5.2 REPLACING THE BRUSH RIM AND SANDING HEAD COVER

The sanding head is surrounded by a brush rim. This ensures that the majority of the dust collected remains
underneath the sanding head and can be extracted by the connected vacuum cleaner. The brush rim is a
part that is subject to wear and tear.
The sanding head cover with the brush rim must be replaced when the brushes are no longer able to provide
until you hear the lock make a clicking sound. Turn the hook & loop pad to the left until it can be removed.
Now press the cover against the set of springs and then use pliers to remove the locking ring which connects
the cover to the transmission housing. Detach the suction hose and remove the cover. Beware of pressure
springs coming loose!
5.3 REPLACING THE HOOK & LOOP PAD
and then attach a new pad so that it sits centered on the disc.

5.4 REPLACING THE CARBON BRUSHES

The carbon brushes are subject to wear and tear and need to be changed regularly. The inspection and
approx. 7 mm.
The inspection and replacement of carbon brushes should only be carried out at MENZER service workshops.
Correction
1. Clean the suction system.
2. Empty the bag.
Apply less pressure when using
the machine.
EN 7