Menzer ETS 150 5.0 Traduction De La Notice D'utilisation Originale page 26

• Immediately disconnect the machine from
mains electricity when taking a break or finishing
work for the day.
• Make sure to keep the power cable of the
power tool at a safe distance from the driving
disc to further reduce the risk of electrocution.
That will minimise the risk of damage to the
cable insulation or cutting through the cable with
the abrasive and also prevent the cable looping
around your hand or arm.
• Unplug the mains plug immediately if the elec-
tric cable is damaged.
• Do not pull the electric cable around corners,
as this might result in kinks or tears in the cable,
which could then cause additional damage at a
later time.
• Never pull on the electric cable and only use the
actual plug to unplug the electric power tool. Do
not suspend the power tool by its power cable.
• Switch off the machine before replacing the
sanding disc, polishing disc or the polishing pad.
• Disconnect the machine from mains power
before replacing the driving disc.
• Do not expose any part of the power tool to
caustic media (e.g. chemicals) or excessive heat
(above 60 °C).
• Do not attempt to make technical changes to
the power tool.
• Keep the electric power tool away from rain and
moisture.
• Use only MENZER-recommended abrasives and
driving discs compliant with the intended use
and the power tool dimensions. All accessories
must fit the drive shaft exactly to prevent uneven
running, vibration and loss of control over the
power tool.
• Deteriorating adherence of the hook & loop
layer on the driving disc may cause accessory
parts for the driving disc (e.g. sanding discs)
to detach and cause injuries. This may occur
specifically during non-contact operation. The
driving disc must therefore be replaced, once
adherence deteriorates.
6 EN
• Only use sanding discs of the correct
size and in compliance with manufacturer
recommendations.
• Do not attempt working with used or worn and
adapted sanding discs from larger electric power
tools.
• After a fall of the power tool, check the electric
power tool and the driving disc for visible
damage. Remove the driving disc for thorough
inspection.
Contact your MENZER Service workshop for
repairs of any damaged parts before use.
A broken driving disc and damaged machines
may cause injuries or negatively impact the
handling of the power tools.
• The use of damaged accessories is prohibited.
All accessories and the driving disc must be
checked and replaced as needed before every
use and after a fall or other potentially damaging
occurrence.
• Do not use accessories with a rotational speed
that does not match or is lower than the max. ro-
tational speed stated on the electric power tool.
• Only use the random orbital sander on dry
substrates. Do not use water or any liquid cool-
ing lubricants, as these could facilitate poten-
tially fatal electric shocks.
• Do not operate the machine directly next to
or very close to your body to prevent cuts or
more serious injuries. The electric power tool
must only be carried on the body when it is at a
complete standstill.
• Put down the machine only after it was
switched off and the driving disc has come to a
complete standstill to prevent hooking or recoil.
• Never put down the machine on top of its
operating lever.
• Regularly clean the ventilation slits on the ma-
chine to maintain proper cooling and to prevent
electrically conductive dust deposits, as these
pose an electrocution or short circuit hazard.
Disconnect the machine from mains electricity
and use compressed air to clean the ventilation
slits.