Maintenance And Service (See Also Page *2*); General Information; Replacing The Abrasive; Replacing The Driving Disc - Menzer ETS 150 5.0 Traduction De La Notice D'utilisation Originale

6. Maintenance and service
6.1 General information
The mains plug must be disconnected from the
mains socket before carrying out any work on the
power tool!
Do not use water or any liquid cleaning agents!
All housing parts and operating elements must be
cleaned with dry, clean compressed air regularly!
Make sure that the ventilation slits in the housing
are free and clean at all times!
Regularly clean the extraction zone underneath
the driving disc and the opening to the extractor
guide around the sanding disc with compressed
air, a fine brush or a dry cloth. Check the con-
nection cable, mains plug and other power tool
components regularly for visual damage and have
them replaced by your MENZER Service workshop
as needed!
All repairs on the power tool and any works that
entail opening any of the device components must
be carried out by MENZER Service!
6.2 Replacing the abrasive (see page *2*)
Detach the worn abrasive from the driving disc
and press on the new abrasive centrically in the
same position. The hook & loop layer will hold it
in place.
Ensure proper alignment of the extraction open-
ings and select a grit size appropriate for the
intended use (please read chapter 5.3 Commis-
sioning).
Never use the power tool without an
attached abrasive. Sanding without an
abrasive would destroy the driving disc.
6.3 Replacing the driving disc (see page *2*)
Only use OEM driving discs! To replace the driving
disc, insert the spanner between the driving disc
and the sealing collar to hold the drive shaft in
place. Now you can rotate the driving disc in the
machine's rotation direction to remove it from the
drive shaft.
Place the new driving disc with distance ring onto
the drive shaft and rotate it onto the shaft against
the rotational direction of the machine to the stop
and tighten it in place.
Don't forget to remove the spanner!
Never operate the device without the
driving disc. Only the overall system is
balanced, coordinated with one another.
EN 11