Meister TS800M Traduction Du Manuel D'utilisation Original page 47

5461560-Tischkreiss_man 22.08.18 14:13 Seite 47
• After switching off the saw do not try
to slow down the moving saw blade
by pressing it from the side.
• Fit well sharpened, crack-free and
undeformed saw blades only.
• Do not use circular saw blades of
high-alloy high-speed steel (HHSS).
• Only tools which conform to per
EN 847-1 may be used on the saw
bench.
• Defective saw blades must be
replaced immediately.
• Do not use saw blades which do not
conform to the characteristic data
specified in these operating instructions.
Do not expose to rain or moisture.
• Ensure that all of the mechanisms
that cover the saw blade are fully
functional.
• The moveable safety hood (1) must
not jam fast when open.
• Safety fixtures on the saw bench
must not be removed or made
unusable.
• Damaged or defective safety fixtures
must be replaced at once.
For every task carried out, the
protective hood (1) must be
lowered onto the work piece.
• When cutting slim work pieces
lengthwise always use the push
stick (18) (width less than 120 mm).
Wear appropriate
protective gear,
such as goggles,
ear defenders and mask.
• Always ensure that the splitting
wedge is correctly set for the work.
• Adopt a working position to the left of
the saw blade.
• Ensure that cut off wood pieces are not
caught by the blade and sent flying.
• Never remove loose splinters, chips or
jammed wood pieces while the saw
blade is moving.
• Before repairing faults or removing
jammed wood pieces switch the saw
off and pull out the mains plug.
• If the saw slot has been knocked out
of position, replace the bench liner (6).
Pull out the mains plug first.
• Before switching on check that all
spanners and setting tools have been
removed.
• When leaving the workplace, switch
off the motor and pull out the plug.
• After carrying out repair or
maintenance work all safety and
security fixtures must be replaced
immediately.
• The manufacturer's safety, working
and maintenance instructions and the
dimensions stated in the Technical
Information must be adhered to.
• The relevant regulations for the
prevention of accidents and other
generally recognised safety regulations
must be followed,
47