Installation; Installation Information; Installation Conditions And Preparations; Power Supply - Stiebel Eltron IW 120 Utilisation Et Installation

INsTALLATIoN

Installation
9. Installation
9.1

Installation information

- Wood ceilings may become hot even if the minimum clear-
ances are observed. Dark spots or fine shrinkage cracks on
wooden ceilings may therefore occur.
- Never install the appliance directly below a socket.
9.2

Installation conditions and preparations

- Only install the appliance in a fixed position, horizontally on
the wall. Never install the appliance on the ceiling.
- Install the appliance with the pull cord at the bottom. The
appliance can only be pivoted downwards.
- Always maintain the specified minimum clearances. Install
the appliance so that the pull cord cannot be reached from
the shower or the bath.
WARNING Injury
Install the appliance out of the reach of children.
Power cable
Below plaster:
The connection must be in the area of the mounting panel.
Above plaster:
f Feed the electrical power cable into the mounting panel via f
the cable grommet.
If installation conduit projects 3.5 to 4 cm into the mounting panel,
the cable grommet is not required.
9.3

Power supply

f Observe the minimum size of the power cable, which can be f
found in the chapter Specification.
WARNING Electrocution
The appliance must be connected to a fixed power cable
(the appliance does not have strain relief). The appliance
must be able to be separated from the power supply by
an isolator that disconnects all poles with at least 3 mm
contact separation. Ensure that the appliance is earthed.
Material losses
Observe the type plate. The specified voltage must match
the mains voltage.
10. Installation
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
f Remove the polystyrene inserted into the grille as transport f
protection.
12 | IW 120
287998-40281-9268_IW 120_de_en_fr_cs_ru.indb 12
f Undo both screws on the pivot hinge of the mounting panel. f
f Undo the two screws on the panel cover above the terminals f
and remove the cover. This releases the pivot limiter and you
can then tilt the appliance forwards.
260
f Mark the fixing holes on the wall. f
f Drill the holes and then insert rawl plugs. f
f Secure the appliance to the wall using the screws supplied or f
other suitable fixing material.
f If you have installed the power cable on a finished wall, in- f
sert the cable grommet into the circular panel hole on the
connection side. Route the power cable through the cable
grommet.
f Insert the cap into the opposite circular panel hole, or into f
both panel holes if you have installed the power cable on an
unfinished wall.
f Connect the cable to the free terminals on the appliance. f
Material losses
Ensure that you do not strip too much of the power cable
to prevent any wires from touching the screws.
f Pivot the appliance upwards. Refit and secure the panel f
cover. This protects the connection space and limits the piv-
oting range to approx. 30°.
f Adjust the tilt angle as appropriate and secure the pivoting f
mechanism by tightening both screws previously undone.
Material losses
Ensure that the appliance does not touch the power cable
after installation and assembly.
www.stiebel-eltron.com
25.10.2017 15:34:45