Test Symbols; Appliance Description; Operation; Cleaning, Care And Maintenance - Stiebel Eltron IW 120 Utilisation Et Installation

operATIoN

Appliance description

WARNING Burns
Never place any objects on top of the appliance. Never
lean any objects against it or place any objects between
the appliance and the wall. Never place any flammable,
combustible or insulating objects or materials, such as
laundry, blankets, magazines, containers with floor pol-
ish or napsan, spray cans or similar, in direct proximity
of the appliance. Never cover the appliance.
WARNING Electrocution
Never insert any object into any aperture in the appli-
ance. This can lead to fatal electric shocks and/or fires.
Material losses
Never place or wind the power cable or the pull cord
around the appliance.
Note
Never touch the quartz tubes with your fingers.
2.3

Test symbols

See type plate.
3. Appliance description
The appliance only warms the air slightly. It is only when it hits
objects or the human body that the IR radiation is converted into
heat. You will feel the heat after just a few seconds. The appliance
therefore provides energy-saving heat, which is available quickly
and on demand at any time.
4. Operation
When the indicator shows stage 0, the appliance is off.
f To start the appliance, pull the cord down vertically. f
The indicator then switches from "0" to "1". You can select two
other heating stages. To do this, pull the cord again for each stage.
f To switch the appliance off, keep pulling the cord down until f
the indicator shows "0" again.
5.

Cleaning, care and maintenance

Note
Never spray the appliance with water.
- Before cleaning, switch off the appliance and leave it to cool
down.
- A damp cloth is sufficient for cleaning the casing. Never use
abrasive or corrosive cleaning agents! Go over with a soft
cloth.
- If the reflector is extremely dirty, arrange for it to be cleaned
by a heating contractor to retain the full heat radiation of the
appliance.
www.stiebel-eltron.com
287998-40281-9268_IW 120_de_en_fr_cs_ru.indb 11
6.

What to do if...

... the appliance does not radiate any heat
f Keep pulling the cord until you get to stage 0. Then start the f
appliance (see chapter Operation).
f Check whether the fuses/MCBs have blown/tripped or are f
faulty.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (no. XXXXXX - XXXX - XXXXXX): The
type plate is located on the back of the appliance, on the inside
of the mounting panel.

INsTALLATIoN

7.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
Note
If installing the appliance in rooms with a bath and/or
shower, take the relevant safety zone into account in
accordance with the information on the appliance type
plate.
8. Appliance description
8.1

Standard delivery

- Screws
- Rawl plugs
- Cable entry
- Cap (2x)
IW 120 | 11
25.10.2017 15:34:45