Safety Instructions - Medela Vario Mode D'emploi

– Separation from the mains is only assured through the disconnection of the mains plug and
the fixed mains socket.
– Before you plug in the device, please check that your local power supply is the same as the
voltage given on the specification plate.

Safety instructions

– The Medela Vario is a medical device that requires special safety measures in regard to EMC.
It must be installed and put into operation in accordance with the EMC information in annex
"I Technical documentation (EMC)".
– In the case of overflow, inform the internal technical service immediately and perform the tasks
in the service manual.
– In each of the following cases, the device must not be used and it must be repaired by
Customer Services:
– if the power cord or the plug are damaged
– if the device is not functioning perfectly
– if the device is damaged
– if the device shows clear safety defects.
– Keep the power supply cord away from hot surfaces.
– The mains plug and the on / off switch must not come into contact with moisture.
– Never pull the mains plug out of the fixed mains socket by pulling on the power supply cord!
– Never leave the device unattended when it is switched on.
– The pump must stand upright during use.
– Never place the power supply cord around your neck.
– Never use the device at high room temperatures, while bathing or showering, if you are very
tired or in an environment where there is a risk of explosion.
– Never place the device in water or other liquids.
– When using single use, sterile products, please note that they are not intended to be
reprocessed. Reprocessing could cause loss of mechanical, chemical and / or biological
characteristics. Reuse could cause cross contamination.
– Contact your local Medela customer service representative for assistance with product
operations.
– Do not place a 2 l suction jar in the lateral adaptor.
– The overflow protection / bacteria filter protects the pump against overflow. Caution: Suctioning
is interrupted when the filter is wet / moist or clogged. Test the filter before each use and
during use periodically (see chapter 17).
These instructions for use must be kept for later reference.
Warnings and safety instructions
| 7