Storage - EMAK MTT 2500 Manuel D'utilisation Et D'entretien

EXTRA MAINTANANCE ADVISABLE
It is advisable to inspect the machine by a
I
specialized technician at an authorized service
network at the end of season, if used intensively,
and every two years if with normal use.
GB
WARNING! – Any maintenance operations
not specifically dealt with in this manual
must be carried out by an authorised service
F
centre. To ensure that your chainsaw continues
to function correctly, use only ORIGINAL
REPLACEMENT PARTS.
D
Any unauthorized changes and/or
use of non-original replacement parts
may result in serious injury or death to the
E
operator or third parties.
TRANSPORTION
SK
Carry the chainsaw with the engine stopped,
guide bar to the rear and chain cover on (Fig. 29).
WARNING - When transpor ting the
P
machine on a vehicle, ensure that it is
firmly and securely fastened using straps or
belts. The machine must be transported in the
GR
horizontal position, also ensuring compliance
with applicable transport regulations for such
machines.
TR

9. STORAGE

CZ
If the machine is to be stored for long periods:
- Drain and clean the fuel and oil tank in a well-
ventilated area.
RUS
- Dispose of fuel and oil according to the rules
UK
and respecting the environment.
- To drain the tank, start the engine and wait
until the fuel is exhausted and the engine
PL
stops (leaving fuel mixture in the carburettor
could damage the membranes).
- Remove, clean and spray it with protective oil
the chain and the bar.
- Thoroughly clean the air intake slots on the
starter housing, the air filter (Fig. 25) and the
cylinder fins.
- Store the blower in a dry place, preferably not
in direct contact with the ground, away from
36
heat sources and the tanks empty.
- The procedures for returning the machine to
service following winter storage are the same
as for starting up during everyday use
(page 26).
ENVIRONMENTAL PROTECTION
Environmental protection should be a priority of
considerable importance when using the
machine, for the benefit of both social cohesion
and the environment in which we live.
- Try not to cause any disturbance to the
surrounding area.
- Scrupulously comply with local regulations
and provisions for the disposal of oils, petrol,
batteries, filters, deteriorated parts or any
elements which have a strong impact on the
environment. This waste must not be disposed
of as normal waste, it must be separated and
taken to specified waste disposal centres
where the material will be recycled.
Demolition and disposal
When the machine reaches the end of its service
life, do not dispose of it into the environment;
instead take it to a waste disposal centre.
Most materials used in the manufacture of the
machine are recyclable; all metals (steel,
aluminium, brass) can be delivered to a normal
recycling station. For information contact your
local waste recycling service. Waste disposal must
be carried out with respect for the environment,
avoiding soil, air and water pollution.
In all cases, applicable local legislation must
be complied with.
When the machine is scrapped also the CE mark
label must be destroyed together with this
manual.