Factory Settings; Switching Tip Detection On/Off; Keypad - BRAND HandyStep touch Mode D'emploi

>
You have just tested the device and would like to be reminded of the next device test. This way
you ensure that your device is inspected on a regular basis.
a.
Set the date of the last test. This date can be in the past, present or future.
b.
Set the date of the next test. This date must be in the future.
c.
Activate the reminder via the slide switch.
ð
If the test interval has expired, you will be reminded of the new device inspection via a message
in the display.
ð
It is best to set these dates immediately after an inspection has been completed.
ð
If the date of the last calibration is after the current date, it is shown in red.
ð
If the date of the future calibration is before the current date, it is shown in red and the reminder
cannot be activated.

8.9 Factory settings

The device can be reset to the factory settings in this menu item.
Factory settings
The factory settings overwrite all settings made by the user, both in the settings menu and in all avail-
able operating modes. This action cannot be reversed.

8.10 Switching tip detection on/off

If you are not working with BRAND tips or other compatible tips, you can switch off automatic tip de-
tection, in order to reach the volume setting quicker.

8.11 Keypad

6 5 4
HandyStep® touch, HandyStep® touch S 997486
NOTICE
1 Available value range
2 Unit selection
1
3 Delete entered characters one at a time
4 Enter comma
2
5 Discard entry
6 Apply entry
Enter values (e.g. volume) via a keypad in the different oper-
ating modes. Values are entered from left to right, together
3
with the comma. Depending on the available value range
and the possible STEP intervals, up to 3 decimal places can
be entered. Values less than or greater than the value range
shown cannot be applied.
8 Settings
81
Operating manual