BRAND HandyStep touch Mode D'emploi page 67

> Charge the battery before the first use or if you have not used the device for an extended time. This
prevents premature wear of the battery.
> Replace the battery after its service life has been exceeded (~ 3 years), in case of deformation or in
the event of extremely short charging cycles and a resulting shorter duration of use.
> When storing the device, disconnect the battery plug.
Components
3
2
1
Label, rear side
5.3.1 Connecting the battery
A
Open the cover and connect the battery's reverse polarity protected plug firmly and straight into the
socket. The device switches on when you have connected the battery. Then close the cover.
5.3.2 Charging the battery
HandyStep® touch, HandyStep® touch S 997486
NOTICE
1 Battery
2 Contacts
4
3 Reverse polarity protected plug
4 Cable
1 Battery type and use
2 Part identification
3 CE marking
4 Warning label
B
a.
Connect the cable to the power adapter and HandyS-
tep® touch.
b.
Plug the power adapter into the power outlet.
ð
HandyStep® touch is charging.
5 Functions and controls
C
Operating manual
67