Dometic DC-Kit1 Instructions De Montage Et De Service page 10

Installing and connecting the DC kit
Note the following safety instructions during installation:
A
NOTICE!
• Note the location of wiring harnesses, wiring and other components
within the installation area.
• Install the DC kit using the following instructions. Improper installa-
tion of the DC kit can put the safety of the user at risk and lead to
irreparable damage to the DC kit or other devices.
• Disconnect all power supply lines to the individual components and
the roof air conditioner.
Observe the following safety instructions for the electrical connections:
A
NOTICE! Risk of short circuit!
• First, disconnect the 230 V external power supply to the caravan.
• Disconnect the earth connection to the supply battery.
• Disconnect the connection to the starter battery.
• If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
• Do not lay cables which are loose or bent next to electrically
conductive material (metal).
• Fasten the cables securely.
• Ensure the 12 V cables are especially well-protected.
• Check whether you need to fit any additional fuses.
• Do not pull on the cables.
• Do not lay the 230 V mains cable and the 12/24 V DC cable in the
same duct.
• Lay the cables so that they cannot be tripped over or damaged.
Observe the following instructions when selecting the location for installing the
components:
• Make sure the cables are of the correct length.
• Choose a well-ventilated installation location near the supply battery.
7.1 Preparing the installation
➤ Disconnect the following voltage supplies in the vehicle:
– Positive battery terminal
– External voltage supply
10
DC-Kit1
EN