Installing And Connecting The Dc Kit; Preparing The Installation; Installing Components - Dometic DC-Kit PP12 Instructions De Montage Et De Service

DC-Kit PP12, DSP-T12/24
7

Installing and connecting the DC kit

!
WARNING!
• The DC kit may only be installed by specialist companies.
• To prevent the risk of short circuits, always disconnect the negative
terminal of the vehicle's electrical system before working on the vehi-
cle's electrical system.
If the vehicle has a consumer battery, its negative terminal should
also be disconnected.
• The minimum cable cross sections are shown in the following dia-
grams:
– ECL-76: fig. 1, page 3
– ECL-102: fig. 2, page 4
– ECL-103: fig. 3, page 5
A
NOTICE!
• Make sure that you route the on/off cable away from live power
cables.
• When installing, observe the information in the installation and
operating manual for the components supplied and your Dometic air
conditioner.
Observe the following instructions when selecting the location for installing the
components:
• Make sure the cables are of the correct length.
• Choose a well-ventilated installation location near the supply battery.
7.1

Preparing the installation

➤ Disconnect the following voltage supplies in the vehicle:
– negative battery terminal
– external voltage supply
7.2

Installing components

➤ Install the charging current distributor.
Attach the charging current distributor and the corresponding relay so that they
are installed firmly, are dry and well ventilated, ideally in the direct vicinity of the
inverter.
➤ Install the inverter.
EN
Installing and connecting the DC kit
19