Adapter Assembly (Example: Sde Die-Adapter); Mounting Of Respective Die Set Into The Designed Adapter (Example: Pez 100 Die-Adapter) - TE Connectivity AT-SC MK II Mode D'emploi

1-528050-0
9.2

Adapter Assembly (example: SDE DIE-ADAPTER)

- Slide the upper die adapter (1) over the alignment pillars (3) on the lower
die adapter (2) in a centered way.
9.3 Mounting of respective die set into the designed adapter (example:
PEZ 100 DIE-ADAPTER)
- Extract the upper and lower part of the adapter.
- Choose the correct die set.
Remove special screws (1) from the die.
-
Refer the upper and lower die to the right adapter and fasten the screws.
-
INFORMATION:
 Control the right position of the die halves! The size of the profile should be in line!
- If necessary screw in or put the locator on locator holder (2)
(depending on the adapter and the die set you use).
- Slide the upper and lower adapter together.
Page 52 / 94
412-94233 REV. D1
1
3
2
1
2
3
Fig. 9.06
Fig. 9.07
Fig. 9.08